| 1. |
Remove the air intake hose connected to the
throttle body.
|
| 2. |
Remove the accelerator and cruise control
cables.
|
| 3. |
Remove the engine coolant hose and throttle
body. |
| 4. |
Remove the P.C.V. hose and brake booster
vacuum hoses. |
| 5. |
Disconnect the vacuum hose
connections.
|
| 6. |
Remove the surge tank stay.
|
| 7. |
Bleed off the pressure in the fuel pipe line
to prevent the fuel from spilling. |
| 8. |
Disconnect the connector from high pressure
hose.
|
| 9. |
Remove the surge tank.
|
| 10. |
Remove the surge tank and gasket.
|
| 11. |
Disconnect the fuel injector harness
connector.
|
| 12. |
Remove the delivery pipe with the fuel
injector and the pressure regulator.
|
When the delivery pipe is removed, be
careful not to drop an injector.
| |
| 13. |
Disconnect the wiring harness of the coolant
sensor assembly.
|
| 1. |
Install the intake manifold and delivery pipe
reversing the order of the removal procedure.
Tightening
torque
Intake manifold :
19 ~ 21Nm (190 ~ 210kg.cm, 14 ~
15lb.ft)
|
|
SURGE TANK AND INTAKE MANIFOLD
| 1. |
Check the surge tank and intake manifold for
damage, cracking or restriction of the vacuum outlet port, water or
gas passages. |
| 2. |
Check for distortion on the surface using a
straight edge and feeler gauge.
Standard value : 0.15 mm (0.006 in.) or
less
Service limit : 0.2 mm (0.0078
in.)
|
|
